Crawl Space Access Doors

Crawl Space Door

Many homeowners find underground crawl spaces a welcoming addition as they feel it can be used for storing all the extra stuff which could not find place in shed or garage. But most of these crawl spaces are not cemented and full of pests and rodents due to the absence of proper ventilation and a good crawl space access door. Absence of crawl space access doors also results in the water accumulation in crawl spaces which flows freely into these low-lying areas.

One should also install crawl space access doors in their homes as open crawl spaces can prove to be dangerous for your pets and small children. By making use of a crawl space access door you can seal off the area. You can buy a pre-manufactured crawl space access door from you local hardware store or you can build crawl space access doors yourself. You can also take help of a professional to build and install crawl space access door. Though it would be much cheaper to create and add a crawl space access door by yourself. If you are searching for information on how to build and install crawl space access doors yourself, here are steps to get started.

Step by Step guide to build and install crawl space doors

Before you start on your project of building and installing crawl space access doors its essential you gather all the essential materials and tools needed to complete the project. The materials and tools needed to build crawl space access doors include plywood, saw, tape measure, screws, two hinges, electric screwdriver, latch, pencil, and sandpaper, padlock, waterproofing spray or paint.

Step 1:- The first step for building your own crawl space access doors is to correctly measure the space where crawl space access door is to be place so that the door you place is a big fit. Most of the crawl space access doors are attached from outside. Crawl space access door is always made a bit larger than the crawl space opening which you plan to cover. So measure the width and height of the crawl space opening frame which will help you in building crawl space access doors of right size.

Step 2 :- You then need to trace the measurements which you took in step 1 on the plywood with the help of a pencil and then cut the wood along the same lines so that you get a crawl space access door of the correct size. Several crawl space access doors could be cut for a single plywood sheet. After you have cut the crawl space access door then make use of sandpaper to smoothen out the rough surface and remove splinter. Lastly you need to apply a fresh coat of paint or stain the crawl space access door to finish its look.

Step 3:- You have to then attach latch and hinges to your craw space access doors which will make it possible for you to swing the crawl space access door open or lock t shut. The latch would help to keep crawl space access doors in their place while hinge will make it possible for you to open or close the crawl space access door. For added security and safety you can attach a padlock to shut the crawl space access door.

Step 4:- You finally need to attach the completed crawl space access door to the crawl space frame by drilling holes in the places where hinges are to be attached and by fixing them with the screws.

You have finally made the crawl space secure by installing a good crawl space access door.